Signalpoint flammable and toxic gas detector

Specifications

Product Description:

The detector is equipped with an integrated pre-wired junction box and can be installed using conduits or cables and connectors, depending on site-specific standards.

Two basic arrangements are available. Combustible gas detectors provide millivolt bridge output signals for dedicated gas control systems such as Unipoint and are ATEX certified for use in explosive atmospheres. The toxic gas and oxygen detector are designed for use in non-explosive atmospheres.

They power a two-wire 4-20mA loop and can be used in combination with a PLC or a dedicated gas control system.

Signalpoint toxic gas and oxygen editions also offer local LED status display; The green light flashes periodically (good), yellow (warning), and red (alarm). Every second counts, which is why we designed this front-end sensor to ensure a fast response even in the face of "sticky" gases.  

Easy to install. The junction box provides "invisible" mounting for wall and ceiling firmware. The hinged cover of the junction box ensures hands-free electrical connections via the M20 cable/conduit interface.

Maintenance requirements are simple and kept to a minimum. All users typically use the Honeywell Analytics family of industrial controllers and adjust them as needed. At the end of its life, simply replace the sensor before reconfiguring the controller. Sensor replacement kits are available to replace electrochemical sensors in toxic gas and oxygen detectors. For flammable gas sensors, simply replace the new box cover with the sensing element.

Signalpoint offers easy installation and simple maintenance at a low cost. As part of the Honeywell Analytics gas detection system, it will put you in the safe position of gas detection equipment.

Signalpoint combustible and toxic gas detector application environment

Product highlights

One-stop shop
Available in Flammable Gas, Toxic Gas, and Oxygen versions
IP54 is the standard
Suitable for indoor use

Proven sensor technology
Surecell™ electrochemical sensor
Anti-toxic catalytic beads
Fast and reliable

flammable gas type
ATEX Hazardous Area Approval
Performance meets EN50054
Typical service life up to 5 years

Toxic Gas and Oxygen versions
Can be used in indoor non-hazardous areas
Local LED status display (working, A1 and A2)
Performance meets EN45544*
Typical service life up to 2 years* Only available for H2S version

Easy to use
Factory set operation
Easy to replace the sensor
Minimal training required

Easy to install
Can be wall or ceiling mounted
Integrated junction box
Pre-drilled M20 cable interfaces

Annex
Weatherproof enclosure
Flow regulator
Conduit mounting kit
Cone collector

Technical parameters

There is no technical parameter expansion description.

Application range

Sensor: Polyphenylene sulfide (PPS). Integrated junction box: impact-resistant nylon.
According to the EN60529:1992 standard, Ingress protection reaches IP54