ozonegas detectorThe gas concentration signal at the monitoring point is converted into an electrical signal in real time by diffusion mode. The signal is amplified, sampled, compensated for temperature and humidity, and processed after chip operation. If the measured value exceeds the alarm concentration set value, an alarm signal is issued. This product has advanced technology, high performance, high stability, can output 4-20mA and RS485 signals, easy installation and maintenance, and greatly meets the requirements of industrial site safety monitoring for high reliability of equipment. It is widely used in indoor chemical workshops, chemical drug warehouses, smoke monitoring, food factories, wineries, electroplating workshops, laboratories, scientific research institutes and other places.
ozonegas detectorFeatures:
Measurement based on UV absorption.
low power consumption; Battery powered.
Internal data logger with real-time clock.
2 seconds measurement interval.
The on-board microprocessor with interactive menu includes 10s, 1M, 5m, 1hr data averaging options and user-defined adaptive filters.
USB and RS-232 outputs time date, O3 concentration, internal temperature and pressure.
User selected unit and scale factor ozone concentration simulation output.
Two Stage 2 relays for control purposes.
Long life pump.
Bluetooth option for wireless data transfer.
Optional configurations for 3 or 6 channel air sampling.
ozone gas detectorNotes:
1. The operating environment must be room temperature, humidity and atmospheric pressure; Excessive temperature and humidity can damage the instrument.
2. Prevents the instrument from falling from a height or being impacted by severe vibrations.
3. Please operate and use it strictly according to the instructions, otherwise it may lead to inaccurate test results or damage to the instrument.
4. Instruments must not be stored in environments containing corrosive gases.
5. If there is dirt on the surface of the instrument after long-term use, gently wipe it with a clean, soft cloth dipped in water. Do not wipe the instrument with corrosive and hard objects, as this may scratch or damage the surface of the instrument.
6. Avoid using gas impact sensors above the measurement range, otherwise the sensor will be damaged, and man-made damage is not covered by the warranty.