A large amount of toxic and harmful gases will be produced during the production process of the factory. As an operator in a grassroots position, while doing a good job in self-protection, it is necessary to strengthen the prevention of toxic and harmful gases, such as setting up equipment valves, interfaces and key partsfixedgas detector, using the PortableGas Detector to regularly detect and record harmful and flammable gas in special areas. So how to usegas detectorWhat about it? How can I increase the service life of my gas detector? What are the storage requirements? What issues should be paid attention to during use? Let's take a closer look at the small ribbons, I hope it will be helpful to you.
How to use gas detector 1:
Safety checks must be carried out before entering the work area. Undergo corresponding safety protection, such as face shields, gas masks, etc. (depending on the specific usage scenario). Ensure the safety of test personnel, prevent potential safety hazards, and enter the operation area only after there is no problem. When the gas detector alarms, the working face should be evacuated in time and the detection data should be saved. After forced ventilation for more than half an hour, a second measurement and test is performed. The inspector must write the test results in the workplace on the confirmation sheet and take full responsibility for the accuracy of the test data.
How to use gas detector 2:
After the inspection, confirm that the warning sign is flipped according to regulations. The warning sign should be hung in a reliable position at the entrance of the work site, and other personnel should not turn over the warning sign to avoid being affected by other reasons. Workers can only enter the work site after seeing the green surface. The duty team leader supervises and inspects the work of the duty inspectors to ensure the effective implementation of the "Regulations".
Use of gas detector
Use of Gas Detector 3:
Will be portablegas detectorThe probe is placed in the environment to be tested. When the gas being measured leaks, the concentration value shows an increase in value. When the alarm set value is exceeded, the alarm indicator light is on and the alarm sounds. As the probe moves into the leak source, the value on the gas detection concentration display increases and the reading is recorded.
Gas detector usage 4:
Whenportablegas detectorWhen the battery is low, it means the battery is about to run out. Turn off the power in time and charge it with the charger for 10-14 hours each time!
How to use Gas Detector 5:
Plug the power charger into the AC220V power outlet, plug the charging plug into the detector, and turn it on4-in-1 gas detectorPower switch to charge the detector. The green work light comes on and the battery indicator flashes and shows "--". After charging, turn off the power switch and unplug the charger.
Storage requirements for gas detectors
Storage requirements for Gas Detector 1:
Concentration range detected by the gas detector - Before the test, the concentration of the gas is pre-estimated based on previous experience and then detected by the gas detector. If the estimated gas concentration exceeds the detection range of the gas detector, the instrument cannot be used for detection, and the detection range of the gas detector will cause serious damage to the instrument, and the serious situation will directly lead to the scrapping of the instrument.
Storage requirements for gas detector 2:
The service life of gas detectors is different typesgas detectorAlso available in different service life. When purchasing, pay attention to the service life of the instrument, whether it is within the warranty period, or beyond the warranty period, or beyond the warranty period. Gas detectors cannot accurately detect the concentration of toxic and harmful gases.
gas detector3. Storage requirements:
Calibration and maintenance before use - If the instrument is not used for a long time, it will affect the accuracy of the instrument due to temperature, humidity, etc., so the instrument must be calibrated before use; During normal use, the gas detector should be placed in a low-temperature, dry, and sealed environment to extend its service life.